39
6. Gently place the burner trim piece around the burner (see Figure 90). It sits on various support brackets
and fits around the burner tray and up against the firebox liner. Figure 91 shows the burner trim in the
correct position. Ensure a minimum 3⁄8” (8mm) gap is maintained around the burner glass tray (see Figure
95).
7. If the optional rock accent kit was purchased for the DV48, you can place the rocks in a random pattern
around the glass tray. A few can straddle the 3⁄8” (8mm) gap around the glass tray. Try to keep them
I
NSTALLATION
S
ET
-U
P
Figure 94: Example of Rock Placement - Multiple Kits.
Figure 95: Keep Area in Front of Pilot Assembly Clear.
2. Ensure the Rear Brick Panel
Support is in the lower position.
The support is located at the
back of the firebox (see Figure
61). Remove the Support, if
necessary, and move it to the
appropriate placement.
3. Install the Rear Firebox Liner.
This panel rests on top of the
accent lights and Rear Brick
Panel Support. It will stay in
this location as you install the
remaining panels. Refer to Figure
98.
P
ORCELAIN
P
ANEL
K
IT
I
NSTALLATION
:
1. Install the porcelain Light Covers over the Light Cover Base. The tabs on the back of the Light Cover slide
down behind the Light Cover Base. Refer to Figures 96 & 97.
Figure 96: Porcelain Light Covers in Place.
Figure 97: Porcelain Light
Covers Close-up.
looking randomly placed. Keep from placing them
in large piles as they need to be evenly distributed.
Examples are shown in Figure 93 & 94.
It is important that rock accents are not placed in
front or over the pilot assembly. This may prevent
the burner from lighting in a timely fashion or
overheat the pilot assembly. Keep an area of about
3” (75mm) in front of the pilot light free from
obstruction and rock accents (see Figure 93).
Figure 93: Example of Rock Placement - Single Kit.
Summary of Contents for DV48
Page 52: ...WIRING HARNESS 52 ...
Page 57: ...PARTS DIAGRAM 57 ...
