37
I
NSTALLATION
S
ET
-U
P
Figure 82: Log 8 in Place.
Figure 83: Log 9 in Place.
8. Situate Log 8 between the right grate
finger, the right firebox liner and the grate
cross bar (see Figure 82). On the back of
the log near the top end is a ceramic pin,
this pin sits into a groove on the top of Log
2.
9. Sit the Y shaped Log 9 across Log 4 and 5
as shown in Figure 83.
10. The final little Accent Twig sits on the front
ceramic burner accent and the grate finger
as shown in Figure 84.
NOTE
: Variances in gas quality or log
placement may cause some discoloration
of the log set to occur.
Figure 84: Accent Twig in Place.
G
LASS
B
URNER
I
NSTALLATION
:
Figure 85: Mixing Tubes in Glass Burner.
Figure 86: Placing Glass Burner.
1. In the bottom rear of the firebox there are two
(2) gas orifices in a housing that facilitate the air
shutter mechanisms and the Burner Mounting Brackets are above them (See Figure 68). There are two (2)
mixing tubes underneath the back of the burner (see Figure 85). Lift the burner into the firebox with the
back of the burner tilted downward. Keep the burner high enough at the front to clear the pilot assembly.
Line up the mixing tubes with the holes in the burner mounting brackets and slowly lower the front of the
burner over the pilot assembly (see Figure 86).
Summary of Contents for DV48
Page 52: ...WIRING HARNESS 52 ...
Page 57: ...PARTS DIAGRAM 57 ...
