Westgate DV48, Owner'S Manual

Page: 34 / 60

I
NSTALLATION
S
ET
-U
P
L
OG
B
URNER
/ E
MBER
B
ED
I
NSTALLATION
:
1. Use the two (2) T-20 screws provided; install
the rear burner shield onto the back of the
burner. The mounting holes are just above the
mixing tubes at the rear of the burner, refer to
Figure 67.
Figure 67: Installing Rear Burner Shield.
Figure 68: Burner Mounting Brackets.
Figure 69: Log Burner Over Pilot Assembly.
34
2. In the bottom rear of the firebox there are
two (2) gas orifices in a housing that facilitate
the air shutter mechanisms and the Burner
Mounting Brackets are above them (See
Figure 68). There are two (2) mixing tubes
underneath the back of the burner (see
Figure 67). Lift the burner into the firebox
with the back of the burner tilted downward.
Keep the burner high enough at the front to
clear the pilot assembly. Line up the mixing
tubes with the holes in the burner mounting
brackets and slowly lower the front of the
burner over the pilot assembly (see Figure
69).
Figure 70: Log Burner in Place.
Figure 71: Burner Accents Pieces in Place.
3. Pull the burner forward up to the angular brackets near
the front of the firebox (see Figure 70).
IMPORTANT: If the burner is not far enough back
to lower the burner behind these brackets, then the
mixing tubes are not engaged in the air shutter. Failing
to ensure the mixing tubes are located in the mixing
tube support brackets may cause serious performance
and or safety issues.