47
S
TART
-U
P
& O
PERATION
Figure 116: Remote Control with Aux for Accent Lights.
Key lock
This function will lock the keys to avoid
unsupervised operation. To activate this function,
press the MODE and UP keys at the same time
and the a lock will appear (see Figure 117). To
de-activate this function, press the MODE and
UP Keys at the same time.
Low Battery Power Detection
Transmitter: The life span of the remote control
batteries depends on various factors: quality
of the batteries used, the number of ignitions
of the appliance, the number of changes to
the room thermostat set point, etc. When
the Transmitter batteries are low, a Battery
Icon will appear on the LCD display of the
Transmitter (see Figure 118) before all battery
power is lost. When the batteries are replaced
this Icon will disappear.
Receiver: The life span of the Receiver batteries
depends on various factors: quality of the
batteries used, the number of ignitions of
the appliance, the number of changes to the
room thermostat set point, etc. When the
Receiver batteries are low, No “beep” will be
emitted from the Receiver when it receives an
On/Off command from the Transmitter. This
is an alert for a low battery condition for the
Receiver. When the batteries are replaced the
“beep” will be emitted from the Receiver when
the ON/OFF Key is pressed (See
Initializing
The System For The First Time
).
Manual Bypass Of The Remote System
If the batteries of the Receiver or Transmitter
are low or depleted, the appliance can be turned
Figure 117: Remote Control
Locked.
Figure 118: Low Battery
Indicator.
on manually by sliding the three position slider switch on the Receiver to the ON position. This will bypass the
remote control feature of the system and the appliance main burner will come on.
Split Valve Operation
The split flow operation on the DV48 turns off the rear section of the burner, greatly reducing the heat output
of the unit. If you’d like to have the fireplace on but would not like to have as much heat in the room, you
can turn off this function. Press the bottom key of your remote repeatedly until the double flame icon is lit up
(refer to Figure 119). By pressing the up or down key, turn the rear split valve to “on” or “off”. The rear flame
on the burner will turn on and off. This does not affect the flame setting of the remaining flame. Turning off
the rear section of this burner may result in an extinguishing “pop”, particularly if your fireplace is operating
on propane gas
WARNING: Fire Hazard. Can cause severe injury or death The Receiver causes ignition of the
appliance. The appliance can turn on suddenly. Keep away from the appliance burner when
operating the remote system or activating manual by pass of the remote system.
Figure 119: Split Valve Indicator.
Summary of Contents for DV48
Page 52: ...WIRING HARNESS 52 ...
Page 57: ...PARTS DIAGRAM 57 ...
