m
2000D
technical manual
Page 37
620 DLC Slave Line Status: non-calibration command
This command can be executed in or outside of calibration mode. This command will
indicate to the user how many slaves were found to be online. The results can be
interpreted as follows:
q
0 – no slaves found to be online
q
1 – only Primary slave found
q
2 – only Secondary slave found
q
3 – both Primary and Secondary slaves found
GENERAL DLC
COMMANDS
TIP:
If both slaves are configured for the same slave ID, no slaves will be detected. If
the user has only one DLC installed, it should be configured as the primary slave. If
the user has two DLC slaves installed, the slave with the largest number of cells should
be configured as the primary slave.
