m
2000D
technical manual
Page 33
592 Restore System Setup From DLC slave: calibration command
This command is a calibration command. It will restore a previous backup from any one of
the two DLC slaves to the master indicator. This command goes hand in hand with
calibration command
591
– used to backup the system data. This process will overwrite
any existing setup information with that provided by the backup stored in the DLC slave.
The information affected is the calibration information and the action tables. For this
command to work correctly, the correct number of DLC slaves should be connected to the
network in order to facilitate a correct system configuration. This command is of use in the
following scenarios:
q
After a typical calibration session, it is recommended to back up the calibration and
action table information, for possible disaster recovery scenarios.
q
It might be useful to provide a user with a pre-configured DLC in the field, in order to
speed up the installation process.
q
The user would like to revert to a backup due to a setup failure or corruption of system
data during installation or maintenance.
This command requires a parameter to specify the slave from which the backup should be
obtained, as follows:
q
1 – restore system data from Primary Slave
q
2 – restore system data from Secondary Slave
To exit this command press the [CLEAR] key.
GENERAL DLC
COMMANDS