Detailed Description of the Parameters
.
132 | CTW900
Description:
It indicates the present encoder speed in revolutions per minute (rpm) with filter of 0.5 s.
P0039 – Counter of Encoder Pulses
Adjustable Range:
0 to 40000
Factory Setting:
Properties:
RO
Groups of
09 READ ONLY PARAMETERS
Access via HMI:
Description:
These parameters show the count of the encoder pulses, which can be in the up (forward spinning) or down
(reverse spinning) mode.
P0040 – Tacho DC Speed
Adjustable Range:
0 to 65535 rpm
Factory Setting:
Properties:
RO
Groups of
09 READ ONLY PARAMETERS
Access via HMI:
Description:
It indicates the present motor speed in rpm through the feedback by Tacho DC (when connected).
P0041 – Speed by EMF
Adjustable Range:
0 to 65535 rpm
Factory Setting:
Properties:
RO
Groups of
09 READ ONLY PARAMETERS
Access via HMI:
Description:
It indicates the present motor speed in rpm calculated by the value of EMF.
P0042 – Time Powered
Adjustable Range:
0 to 65535 h
Factory Setting:
Properties:
RO
Groups of
09 READ ONLY PARAMETERS
Access via HMI:
Description:
It indicates the total number of hours that the converter remained powered.
This value is kept even when the converter is powered down.
P0043 – Time Enabled
Adjustable Range:
0 to 65535 h
Factory Setting:
Properties:
RO
Groups of
09 READ ONLY PARAMETERS
Access via HMI:
Description:
It indicates the total time the converter remained enabled (‘Run’, ‘Up Ramp’ or ‘Down Ramp’ status).
This value is maintained even when the converter is powered down. If you wish to reset this parameter, set
P0204 = 1.
P0044 – kVAh Counter
Adjustable Range:
0 to 65535 h
Factory Setting:
Properties:
RO
Groups of
09 READ ONLY PARAMETERS
Access via HMI:
