2.0
LET'S GET STARTED
2.2 Site Planning Guidelines
2.1 Unpacking your BOUNTI
As you unpack the
, check that you have all the
parts shown below and that none have been damaged during transportation.
1.
2. Paper roll ( Stationery )
3. Power Adaptor
4. User Guide
5. Serial Interface Cable
6. Warranty Manual
After removing the parts, save the packing materials in case you need to
transport your
BP20/20T/25T/50T/85T
BP20/20T/25T/50T/85T
BP20/20T/25T/50T/85T
BOUNTI
BOUNTI
product.
•
Place the product on a flat and stable surface.
•
Leave adequate room around product for easy operation,
maintenance and proper ventilation.
•
Avoid connecting product to plug points where any other equipment
like large motors, AC or other appliances which might cause
fluctuations in the voltage .
•
Recommended to place the product where the dust level is minimum.
2.3
Power conditioning equipment
•
Ensure that the input supply to your product is within the specified
limits as given below:
a. Nominal voltage : 220VAC
b. Voltage range : 150 to 270 V AC
c. Ground to Neutral Voltage : Less than 3 V AC
d. Frequency : 47 to 53 Hz
•
Recommended to use voltage stabilizer/CVT/UPS to ensure regulated
power supply to your product.
3.0
SAFETY PRECAUTIONS
Please read the manual before using the
to avoid dust collection and to reduce noise
during printing.
Do not remove Key Pad Module while printing & ensure that it does not
hang with the cable to avoid damage to the cable.
Do not insert or remove the interface cable when the
is in
ON condition.
Do not insert or remove the interface cable when the
is in ON
condition during program download.
•
•
Ensure that the protective materials are removed before installation.
•
Do not expose your
to direct sunlight, excessive heat, moisture or
dust.
•
In case of printing abnormality, do not dismantle any part from
. Call
your nearest Authorised Service Provider listed in Warranty Booklet.
•
Keep Key Pad Module intact
•
•
•
product.
product
product
product
product
3
