29
WellGate 3804 User Manual
5.5 [flash] command
This command will clean the configuration stored in the flash rom and reboot
WellGate FXO GateWay in factory default setting.
Parameter Usage:
-clean
clean all the user-defined value, and reboot WellGate FXO
GateWay in factory default mode.
Note: It is recommended that use “flash –clean” after application firmware id
upgraded.
Warning
:
Once users execute
flash –clean,
all the configurations of
WellGate FXO GateWay will be cleaned. This can only be executed by user
who log in with
root
5.6 [commit] command
Save changes after configuring the WellGate FXO GateWay.
-------------------------------------------------------------------------------------------------
usr/config$ commit
This may take a few seconds, please wait....
Commit to flash memory ok!
usr/config$
Note: Users should use
commit
to save modified value, or they will not be
activated after system reboot
.
5.7 [ifaddr] command
Configure and display WellGate FXO GateWay network information.
usr/config$ ifaddr
LAN information and configuration
Usage:
ifaddr [-print]|[-dhcp used]|[-sntp mode [server]]
ifaddr [-ipsharing used [deviceAddr]]
ifaddr [-ip ipaddress] [-mask subnetmask] [-gate defaultgateway]
Display LAN information and configuration.
-ip
Specify WellGate FXO GateWay ip address.
-mask
Set Internet subnet mask.
-gate
Specify default gateway ip address
-dhcp
Set DHCP client service flag (On/Off).
-sntp
Set SNTP server mode and specify IP address.
-timezone Set local timezone.
-cmcenter
Set Management Center IP Address.
Summary of Contents for 3802 FXO
