POWER
Blue
. Steady glow indicates power supply is
OK. Off indicates no power.
IDENTIFY
Blue.
Blinks when identify is active.
DMX INPUT
A/B
Amber
. Steady glow indicates port latched to
active DMX source. Input and Output off on all
ports indicates no DMX source.
DMX OUTPUT
A/B
Green
. Steady glow indicates port is transmit-
ting DMX. Input and Output off on all ports indi
-
cates no DMX source.
NETWORK
LINK/ACT
Green
. Flickering glow means active Ethernet
network link. Off indicates no network link.
Model 6822 2-Port Gateway
Manual
11/06/20
The Pathport® 6822 2-Port Gateway provides the full
functionality of other Pathport gateways in a compact, DIN-
rail mountable form factor.
System integrators can now easily put fully customized
universes of DMX where they’re needed.
Ideal for use in NEMA enclosures. Fully compatible with
eDIN interfaces.
The Pathport 6822 features terminal strips that can be removed
from the card to facilitate easy wiring installation or replacement.
Make the following connections,
WITH THE POWER TURNED
OFF.
POWER
The 6822 is designed to run on either Power-over-Ethernet (PoE),
or on an auxiliary power supply providing between 18 and 48 volts
DC. The gateway is Class 1 PoE and will draw up to 4 Watts.
If an auxiliary supply is used, observe the correct polarity when
connecting V+ and V-. A second set of terminals are provided so
power may be daisy-chained to other cards. The earth ground
terminal must be connected to the enclosure’s chassis or electrical
ground terminal to ensure EMC compliance.
DMX512
DMX connections consist of a shield and data pair. Connect DATA+
and DATA- to D1+ and D1-. Observe the same polarity convention
throughout the system. Connect the cable shield or common to the
SHLD COM terminal.
NETWORK
All network wiring should follow standard Ethernet rules and be
installed by a qualified person. As part of the installation, all wiring
should be certified under the TIA/EIA-568 standard.
OVERVIEW
CONNECTIONS
STATUS INDICATORS
NC
NC
D1+
COM SHLD
D1-
DMX -
A INPUT
DMX PORT A
NC
NC
D1+
COM SHLD
D1-
V+
V-
GND EAR
TH
V-
DMX -
A OUTPUT
DMX - B INPUT
DMX - B OUTPUT
AUX POWER IN
18 - 48VDC MAX 4 W
DMX PORT B
V+
POWER
NET
LINK /
ACT
IDENTIFY
POWER IN (If PoE not in use):
18-48VDC, 4W Supply required.
Use #1001-100-48-DIN PSU or equal.
Fastening mechanism designed
for 35 x 7.5mm DIN rail
DMX512 INPUTS/OUTPUTS (2)
LED INDICATORS
Female RJ45
Ethernet Connector
