WELLSYSTEM Medical_Plus, Operating Instructions Manual

Page: 111 / 144

Operation
03/2018 1009909-05 Operating instructions – 39/70
3.7.1 For programming specific phases
Up to 45 different phases can be defined for a massage program using this
programming mode. All of the basic settings (massage pressure, body area,
type of massage, etc.) can be set up separately for each phase.
A single phase must last for at least 1 minute and up to a maximum of 45
minutes. The times must be entered using minute cycles. The defined phases
will run in sequence. The sequence will be repeated until the entered mas-
sage time has expired.
NOTE:
Pay special attention to the full massage time when creating
a program. Not all of the phases can be run if, for example, a
program has 40 phases and each one last for one minute
but the overall time entry was only 30 minutes! The massage
will stop after the 30th phase.
An example program with 3 phases is shown below.
The PH.01 display will alternate with the phase duration (in minutes). Use the
plus or minus buttons to select the phases.
Phase Configuring
the settings Button sequence Example set-
ting /
Display
Optional: Insert chip
card
Start Press and hold the save pro-
gram button for 3 s.
Massage time
Massage pressure
Speed
Pulse massage
Body area
Massage type
Store the phase
Select a new phase