34
Totalizer. Display shows the status DI, DO, Counter or Totalizer
at the present time
. Counter
and Totalizer are available if the option of Math, Counter & Totalizer was ordered before.
3.6 Exit
Press Exit key to close existing operation, the soft keys on the left hand side disappear giving full
display. Press any soft key on the left hand side, these six soft keys Page, Mode, History, Event,
Status and Exit appear again. Open the plastic cover at the front low side then another five soft
keys Dump, Clear, Operate, Config & Shutdown appear.
3.7 Dump
Before removing the CF card from the recorder, it is necessary to press the Dump key to transfer
the measured data and events from the internal memory of the recorder to the CF card
3.8 Clear
If the internal memory goes down to 25%, the mem icon on the top right changes color from
green to red. Also, when the internal memory reserved for events is down to 25 %, the evnt
( event ) icon on the top right changes color from green to red. In each case the user should
transfer all the measured data from the recorder to CF card by pressing Dump key as above.
However, if the measured data and events are not significant information, the user may also
press Clear key to clear them.
3.9 Operate
Press Operate key to start a job manually. For example: to record the alarm by selecting Log
alarm. There are various jobs that may be assigned, as described in Event, Job of 4.1 Channel.
Details about soft key
Config
are described in 4. Configuration.
3.10 Shutdown
Accidental turning off the power will cause loss of data and will interrupt the operation of the
recorder. Therefore press the Shutdown key to shutdown the system first before turning off the
power.
3. 11 Logout
If a user orders the option of FDA 21 CFR part 11 compliance, and selects this type of high
security, an extra Logout key appears next to Config key. It is used to record the logout time of
the user. Only after the previous user logout from the recorder, the next user may log into the
recorder.
Summary of Contents for WH18/06
