Weco WF-104, Instruction Manual, Page: 32 / 96

WELD THE WORLD
C
od
. 006.0001.0940
16/04/2018 V.2.25 WF-104
WF-108
32
ENGLISH
8 PARAMETERS ACTIVATION
The welding parameters are available in accordance with the selected welding mode and procedure.
Certain parameters are available only after other parameters or functions of the unit have been enabled
or set.
The table shows the settings required to enable each parameter.
√ : always available.
1: available in HSL line power sources on selecting one of the "PF" curves (e.g.: SG2/SG3 PF )
2: Available selecting one of the "PR" curves (e.g.: SG2/SG3 PR )
MENU
↓
MODE
→
PROCEDURE
→
PARAMETER
↓
- Arc correction in Volts         
- Arc correction in metres per minute         
- Arc correction with Power Root
2 2 2
1st Inductance  
2nd Inductance
  
2nd PR Start
2 2 2
2° Arc Set      
2° Pre Gas
          
2° Soft Start           
2° Burn back           
2° Post gas           
2° Power focus
1 1 1
2° Spot time    
2° B-level      
2°
Start 3lev   
2° Crater 3lev   
2° Slope 3lev 1   
2° Slope 3lev 2   
2° Freq 2puls   
2° Range 2puls   
2° Cycle 2puls   
2° Arc2 2puls
  
2° Arc2 2puls   