Weco WF-104, Instruction Manual, Page: 28 / 96

WELD THE WORLD
C
od
. 006.0001.0940
16/04/2018 V.2.25 WF-104
WF-108
28
ENGLISH
CALIBRATION PROCEDURE
HOLD
Menu Menu
m/min
mm
S T O P
L1
L2 L3
L4
L5
L6 L7 L8
L9
L10
L11
L12
L13
L14
L15
S1
S2
S3 S4
S5
S6
S7
S8
S9
S10
E1 E2
E3
D1 D2
D4
Example of control panel (applies to model WF-108)
B
SELECTION
A
SETTING
A
OUTPUT
OUTPUT
B C
The welding power source must be on and not set up for welding.
The power source remote control must be enabled.
A
○ Press and hold down for 3 seconds buttons S5 and S6 .
TOUCH THE WORKPIECE WITH THE GUIDE WIRE TIP AND PRESS THE TORCH
TRIGGER- The message will appear on display: D4
CAL - The message will appear on display: D1
Display D2 will show the welding circuit resistance value (mΩ) measured during the last
calibration. After a total RESET, the default value will appear.
Remove the gas nozzle from the torch and lean the guide wire tip (without the wire) onto the surface
of the workpiece, making sure it sticks well; check that the contact between the guide wire tip and the
workpiece is on a clean area of the piece's surface. Press the torch button to perform the calibration.