Weco Edge 550, Manual

Page: 76 / 221

Utilization... Normal use
Edge 580 - Edge 550
3-75
3.4.5 P
RODUCING A JOB WITH GROOVING AND DRILLING FINISHING
3.4.5.1 O
BJECT
Produce a job with the following characteristics :
HI plastic > Normal lens > Gr Drilling > Groove % > Front and rear safety-bevel > Polishing
Position of middle of groove = 40 % from the front face
Parameters of the groove : width = 1 mm / depth = 0,30 mm
Safety-bevel parameters : front depth = 0,30 mm / rear depth = 0,20 mm
3.4.5.2 P
ROCEDURE
To carry out the job described above, proceed as follows :
Flow chart 3-7 : Production of a job with Grooving and Drilling finishing
Astuce ! To familiarize yourself with the icons associated with each step or obtain more details
of the action required, click on the "object" above or refer to the screen on the opposite
page.
Open a job number
Select HI plastic lens material.
Select NORMAL lens type.
Select GROOVING finishing.
Select % sub-finishing.
Select POLISHING option.
Place the lens in the edging chamber
Start the edging process
Select REAR and FRONT SAFETY-BEVEL.
Using the Parameters menu, enter the following values :
. position of middle of groove from front face = 40
. depth of front safety-bevel = 0.30 mm ;
. depth of rear safety-bevel = 0.20 mm.
Select NORMAL TO FRONT FACE drilling finishing.