Weco Edge 550, Manual

Page: 197 / 221

5-196
Maintenance... Messages
Edge 580 - Edge 550
0x410 Lens too small. Do you want
to continue ? Lens too small or too decentered
in comparison with the shape. YES : the lens is felt again 0.5
mm closer to the interior.
It can be refelt 3 times, 0.5 mm
closer to the interior each time.
NO : remove the lens from the
edging station.
0x411 Small adaptors mounted ? The 19 mm diameter adaptors
are required for the procedure
you have selected. Confirm the message.
Fit the small adaptors.
0x412 Small flat adaptors mounted
? The 17 mm diameter flat
adaptors are required for the
procedure you have selected. Confirm the message.
Fit the small flat adaptors.
0x413 Edging impossible : radius
too small. The shape is smaller than the
smallest adaptor. Confirm the message.
Remove the lens from the
edging station.
0x414 Lens feelers not in position. An irregularity has been
detected during lens feeling. Confirm the message.
Restart the cycle and observe
the lens feeling process :
. if one of the tips is unclipped,
refit it.
. if not, proceed with the lens
feeling adjustment.
0x415 Bevel out of lens The bevel is outside the lens in
at least one point. Confirm the message.
Visualize the defect on the
control screen and proceed as
required.
0x416 Retouch impossible. You have activated the retouch
control and the lens detected
does not match the parameters
of the lens you wish to retouch. Confirm the message.
Remove the lens fitted on the
shafts.
Fit the lens you wish to retouch.
0x41A Lens too thin for grooving.
Do you want to continue ? A thickness of less than 1 mm
has been detected in at least
one point of the lens. YES : The lens is edged with
rimless finishing.
NO : The cycle is stopped.
Remove the lens from the
edging station.
0x41B Lens too small. It can be refelt 3 times, 0.5 mm
closer to the interior each time.
Lens too small or too decentered
in comparison with the shape. Confirm the message.
Remove the lens from the
edging station.
0x41C Drill diameter > hole
diameter. Do you want to
drill ? The diameter of at least one
hole is smaller than the diameter
of the drill.
But the minimum drilling
diameter is equal to the bit
diameter. YES : the hole(s) will be drilled
with a diameter equal to that of
the drill.
NO : the lens is not drilled.
Remove the lens from the
edging station.
0x506 Please remove lens to free
mill bit before
acknowledging message. A defect has occurred when the
mill bit was not in its housing.
The lens could be damaged. Make sure that the machine is
switched off.
Free the lens from the mill bit
carefully.
Restart the machine.
# Message Conditions for display Action