Weco Edge 550, Manual

Page: 193 / 221

Maintenance... Messages
Edge 580 - Edge 550
5-192
0x19 Incompatible edger
configuration
Groove auto not allowed. The job you have loaded calls
for Automatic Groove finishing.
In the personalisation menus,
you have excluded this
parameter, so the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, modifiy the
personalisation of the pull-down
menus.
Select Automatic Groove
finishing.
Load the job again.
0x1A Incompatible edger
configuration
Groove curve not allowed. The job you have loaded calls
for Groove curve finishing.
In the personalisation menus,
you have excluded this
parameter, so the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, modifiy the
personalisation of the pull-down
menus.
Select Groove Curve finishing.
Load the job again.
0x1B Incompatible edger
configuration
Front groove not allowed. The job you have loaded calls
for Front Groove finishing.
In the personalisation menus,
you have excluded this
parameter, so the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, modifiy the
personalisation of the pull-down
menus.
Select Front Groove finishing.
Load the job again.
0x1C Incompatible edger
configuration
Percent groove not allowed. The job you have loaded calls
for Percentage Groove finishing.
In the personalisation menus,
you have excluded this
parameter, so the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, modifiy the
personalisation of the pull-down
menus.
Select Percent Groove finishing.
Load the job again.
0x1D Incompatible edger
configuration
Manual groove not allowed. The job you have loaded calls
for Manual Groove finishing.
In the personalisation menus,
you have excluded this
parameter, so the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, modifiy the
personalisation of the pull-down
menus.
Select Manual Groove finishing.
Load the job again.
0x1E Incompatible edger
configuration
Drilling normal to rear face
not allowed. The job you have loaded calls
for Drilling normal to rear face.
In the personalisation menus,
you have excluded this
parameter, so the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, modifiy the
personalisation of the pull-down
menus.
Select sub-finishing Drilling
normal to rear face. Load the job
again.
0x1F Incompatible edger
configuration
Drilling normal to front face
not allowed. The job you have loaded calls
for Drilling normal to front face.
In the personalisation menus,
you have excluded this
parameter, so the edger cannot
accept this job. Confirm the message.
If you wish to load this job
nonetheless, modifiy the
personalisation of the pull-down
menus.
Select sub-finishing Drilling
normal to front face.
Load the job again.
# Message Conditions for display Action