WebGate HD1600F-PDR Series, User Manual

Page: 52 / 92

51
Monitor
Configure SEQ, MULTI and event pop up.
alarm pop-up
If specific channel uses MD, Sensor Input, it makes the relevant
channel pop-up as single or multi screen. To use this function, event
should be set to event schedule in recording set up and MD /
Sensor configuration should be done also.
If event popup time is configured “off”, event popup will not work.
Event pop-up can be configured per second from 1 to 10 seconds.
If user set Event pop-up as keep, it will show continuously on the
popup screen until the time user push any certain button
Sequence configuration
This menu is to edit function of user sequence configuration. User can configure
16 sequence modes and dwell time is available to set from 5 to 60 seconds.
For sequence mode, users can configure channel or division mode and sequence
time from 5 to 60 seconds. If user set it to Off, this function will not work.
The default value of "Restore after Event-Popup" is off. If alarm popup occurs
during sequence mode, sequence mode will be stopped under this condition. But,
if "Restore after Event-Popup" is on, sequence mode will be activated again after
alarm popup time finishes.
Sequence mode starts when user pushes [SEQ] button.
To escape from Sequence mode, please, push [SEQ] button one more time.
Multi set-up
Select multi screen order through multi set-up. Maximum of 16 screens can be
set-up..
menu

device

monitor