WebGate HD1600F-PDR Series, User Manual

Page: 42 / 92

41
RAID manager
This is the menu that manages RAID of internal HDD and HDD
installed in NS04R.
Steps to configure RAID
1) Select “NO” to all HDD activate in “Disk manager“
2) Select device of creating RAID (DVR/NS04R) in RAID MANAGER“
3) Select RAID Level(1/5/10) after selecting RAID members.
4) Create RAID by clicking “Create RAID” then all selected HDDs will
operate in one “DVR RAID Disk”
5) If you activate “DVR RAID Disk” in Disk manager” it will be sued as
storage of DVR.“
name function description
Raid Member Select disks that need to be in Raid.
Raid Level Select Raid Level 1, Level 5, Level 10.
Create Raid Create Raid with selected Raid Member and Raid Level.
Raid ID Displays Raid ID.
Disk Status Online : HDD is connected, Offline : HDD is not connected.
What is RAID?

Webgate’s DVR models(HD1600F-PDR, HD1600F-R, HD800F-PDR, HD400F-PDR) support RAID function
via built-in hard disk.

RAID(Redundant Array Independent Disk) can store the data using the pre allocated parity territory if
there is an error in hard disk.

Supports RAID 1, 5, 10 and auto restore function when replacing a defective hard disk.
Of hard disks and RAID construction methods.

Depending on the # of hard disks installed in DVR, availability of RAID level will differ.

Refer to the below table for supported RAID level.
HDD # Possible Level Actual # for recording Capacity *
2 RAID 1 50% 100% (480fps)
3 RAID 5 66% 66% (320fps)
4 RAID 10 50% 100% (480fps)
5 RAID 5 80% 66% (320fps)
* To use RAID without lowering performance of DVR, configure RAID only with NS04R
How to deal with a problem occurred?

If a problem was occurred during RAID operation, RAID manager will appear, and the faulty HDD state
will be changed to Offline or Bad from Online.

In this case, please turn off DVR and replace the faulty HDD with same capacitor’s new HDD. If you
turn on the DVR, DVR will start rebuilding automatically. Once rebuilding was started, it will keep
rebuilding at background even if you exit the menu. Please note that completion of proper rebuilding
can ensure the reliability of RAID system.

Please be careful not to replace the normal operation HDD. If you replace the normal operation HDD,
you could lost the data. Be sure to replace the faulty HDD only.
menu

system

disk

RAID manager