Brine fog maker, Type Solfog V2
Index: 01
Change date: 12/12/2017
Operating instructions no.: BA DW 018-01 Solfog V2 EN.docx
Page 20 of 39
5.
Start disinfection
Now the hose pump will convey the disinfection solution into the fog maker
tank, until reaching the required filling level. (This message is not displayed when
there is already liquid in the fog maker tank). Now the disinfection starts
automatically. The disinfection solution is atomised by the ultrasonic fog maker
and is blown by the fan into the fog maker pipe and the connection set.
The disinfection takes 15 minutes.
Take away the
connection set (51)
at the fog outlet in the corresponding cabin.
Confirm the message in the display with Enter.
Empty the brine politainer with the remaining disinfection solution, rinse and
store for the next disinfection. Disassembly, empty and rinse the
fog container
with potable water, and put the empty tank again in its place. Confirm the
message in the display with Enter.
ATTENTION !
Document each disinfection in the disinfection report in
section 9.5.1
CAUTION !
When a fault is produced during the disinfection, it must be remedied and the
disinfection must be repeated.
Now continue with the start-up.
HINT !
At delivery of the device, the politainer has already been connected as protection
against dirt.
5.2.3
Filling and starting the brine fog maker
1.
Switch off the device at the main switch.
2.
Remove the fog maker container Therefore pull the
forward out of the support, and take out downwards.
Empty the fog maker tank, rinse with potable water, and then put the
empty fog maker tank back.
Figure 16, Remove the
fog maker container
