Tools Needed:
28
Please Do Not Return This Product To The Store.
Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the
Find a Dealer
section online at
www.Wayne-Dalton.com
Positioning Support Bracket
24
USING A TAPE MEASURE, MAINTAIN AN EQUAL MEASUREMENT “X”
(TOP OF DOOR TO BOTTOM OF TORQUEMASTER® TUBE) AT BOTH
ENDS AND THE CENTER.
TOP SECTION
“X”
“X”
NOTE:
See
i
drive
®
main installation
instructions and owner’s manual for
i
drive
®
parts.
NOTE:
idrive
®
must be installed on a
solid mounting surface.
Locate the mounting surface. The
mounting surface is a vertical board
running directly above the center of the
door. Remove (2) 1/4”-20 flange nuts
from bottom of opener.
NOTE:
Do not discard flange nuts.
Place the support bracket underneath
opener, to the right side of motor,
centered on mounting surface. Using a
tape measure, level the bottom of the
TorqueMaster
®
spring tube to the top of
the door section with the idrive
®
resting
on the support bracket. Once
TorqueMaster
®
spring tube is level, drill
1/8” pilot holes for the lag screws. Then
secure support bracket to the mounting
surface with (2) 1/4” x 1-1/2" lag
screws.
IMPORTANT:
TORQUEMASTER
®
SPRING
TUBE MUST BE LEVEL AFTER SUPPORT
BRACKET IS FASTEN TO MOUNTING
SURFACE.
NOTE:
If wood mounting surface is
behind dry wall, use 1/4” x 2” lag
screws.
Lift and slide the opener over the
support bracket, aligning the mounting
studs with the bracket slots. Loosely
fasten to mounting studs with the (2)
1/4”-20 flange nuts.
NOTE:
Do not tighten 1/4”-20 flange
nuts to opener studs at this time.
Remove the temporary orange label
holding the antenna wire. Straighten
antenna wire and angle it 45 degrees to
the right.
NOTE:
Do not coil the antenna wire.
This will reduce the radio signal range.
Power Drill
1/8” Drill Bit
7/16” Socket
Driver
MOUNTING
STUDS
BRACKET
SLOTS
SUPPORT
BRACKET
TORQUEMASTER
®
SPRING TUBE
(2) 1/4” - 20
FLANGE NUTS
“X”
ANTENNA WIRE
45° ANGLE
1/4 X 1-1/2”
LAG
SCREWS
SUPPORT
BRACKET
1/4” - 20
FLANGE
NUTS
MOUNTING
STUDS
MOUNTING
SURFACE
(HEADER)
TOP OF DOOR
TORQUEMASTER
®
SPRING TUBE
