Wavez Kymera User’s Manual v
1.7.20181211
Page 6
5
Change the battery following the procedure ”Battery charging”
p11
12
When the battery is fully charged, move the power cable inside the front hatch out
of the way and insert the battery so it is fully seated back into the battery tray and
ensure the battery tray handle is forward
If not, pull the metal knob at one end to release the battery tray handle to move it
forward.
13
Lock the battery in place with the battery tray handle, plug in the power cable and
activate the battery
Listen for a few beep(s) and verify that the battery meter display turns on.
Always wait for ten seconds
after activating the battery to allow the computer
to fully boot up. Failure to do so may result in non-activation or incorrect trigger
setting.
14
Double-check that nothing is obstructing the impeller and gently pull the throttle
trigger to verify that the motor engages
When the board is first turned on there can be a small lag before the motor activates.
Retry if the motor doesn’t engage the first time but don’t pull the trigger hard –
the
motor should never be run hard when the board is out of the water.
If it still won’t activate, did you wait 10 seconds before pulling the trigger? If not,
turn off the battery for at least 10 seconds and then repeat the process.
15
Deactivate the battery, remove the power cable, unlock the battery tray handle,
remove the battery, wipe it down and return it to the hard carry case
You unlock the battery tray handle by pulling the silver knob on the end of the handle
outwards and pulling the handle down.
Carefully close and secure both tabs on the hard carry case.
16
Close and lock the front hatch of the board.
Your board is ready for action!