WAVESHARE ELECTRONICS
WIFI232 User Manual
Page 38 of 81
5.1.2 Quick Configure
This page provides users with a method of rapid configuration module.Users according to the
steps to configure the parameters and restart the module page, you can let the module is normal
work, reduced the configuration steps and time.Of course the options on this page is less, if some
detailed configuration, still need to the corresponding configuration page.
Figure 27
Quick Configure Page
This page has four configuration options and a restart, the corresponding instructions below:
WI-FI Setting: set the working mode of wifi, AP mode or the STA.
Ethernet Ports Setting: open/close the Ethernet ports, and set up the corresponding work
mode.
UART Setting: set serial port parameters, including baud rate, parity bit, 485 functions and so
on.
Network Setting: set network parameters, Only TCPA related parameters.
Device Management: when after completion of the above parameters are configured, click
reset module.
5.1.3 Mode Selection Page
This page use to setting the wireless networking mode (AP and STA mode).
"Data transmission mode" selection module working mode are "Transparent Mode", "Serial Command
mode", "HTTPD Client mode", "GPIO mode".
