WAVESHARE ELECTRONICS
WIFI232 User Manual
Page 55 of 81
Set Operation
AT+ WAKEY=< auth,encry,key><CR>
+ok<CR>< LF ><CR>< LF >
Parameters:
auth: Authentication mode
OPEN
SHARED
WPAPSK
encry:Encryption algorithm
NONE: When “auth=OPEN”, effective;
WEP: When “auth=OPEN”, effective or “SHARED”, effective;
TKIP: When “auth=WPAPSK”, effective;
AES:When “auth=WPAPSK”, effective;
TKIPAES:When “auth=WPAPSK”, effective;
key: password, ASCII code, shall less than 64 bit and greater than 8bit;
This Instruction only effective for WIFI232 works as AP. After WIFI232 module boots up again, the
setting will be effective. But user can set this command when module configured as STA.
5.2.2.2.16
AT+HIDESSID
Function: Set/Query hide AP‟s SSID;
Format:
Query Operation
AT+HIDSSID<CR>
+ok=<sta.><CR><LF><CR><LF>
Set Operation
AT+HIDSSID=<sta><CR>
+ok<CR><LF><CR><LF>
Parameters:
When Query,sta reply
if module‟s SSID is hide;
On-not hide SSID
Off- hide SSID
When Set,
Off-hide SSID
On- not hide SSID
5.2.2.2.17
AT+MSLP
Function: Set modules into power save mode.(Turn OFF WiFi,
Regardless of the AP
mode or the sta mode)
;
Format:
Query Operation
AT+ MSLP <CR>
+ok=<sta.><CR>< LF ><CR>< LF >
Set Operation
