Catalog No. 29290
12
Rev 3 06/2020
3.3.3 Connecting the drain:
a.
MTOL+ drain tubing
MUST
be routed to a suitable
sanitary sewer drain. Wetted materials are not FDA approved.
DO NOT
return the drain sample or any water run through MTOL+
into the process stream or into any potable water supply.
b.
Select a length of ¼ inch OD flexible tubing (Polyethylene or
polypropylene) long enough to directly connect the MTOL+ drain
connection point to a suitable sanitary sewer drain. Avoid
unnecessary bends or sags in the tubing. Make sure there are no
kinks, twists, breaks, or damage of any kind in the tubing.
c.
Using a sharp utility knife, cut the end of the tubing square.
Remove any burrs or sharp edges before inserting into fitting.
d.
Place a piece of tape ½ inch from the end of the tube to indicate
how far the tube should be inserted.
e.
Push the tube into the Quick-Connect fitting on the right facing side
of the MTOL+, as shown in Figure 4.
f.
Check to confirm that tube is pushed fully against the tube stop.
Gently but firmly pull on the tube to check that it is secure.
g.
Connect the other end of the tube to a suitable sanitary drain or
trench following proper plumbing techniques applicable to your
facility and configuration.
3.3.4 Connecting the water intake:
a.
Use MTOL+
ONLY
with water. Connect water intake
ONLY
to water free of corrosive chemicals or other hazardous
substances.
HF scientific accepts no responsibility for damage caused
by the introduction of vapors, fluids or other materials into
the instrument process stream which is not compatible with the
instrument's wetted materials. A list of the wetted materials can be found in
the specifications on page 2 of this manual.
b.
Select a length of ¼ inch OD flexible tubing (Polyethylene or
polypropylene) long enough to directly connect the MTOL+ water
inlet connection point to water sampling point. Avoid unnecessary
bends or sags in the tubing. Make sure there are no kinks, twists,
breaks, or damage of any kind in the tubing.
Summary of Contents for HF scientific 28052
Page 2: ...Catalog No 29290 Rev 3 06 2020 ...
Page 5: ...Catalog No 29290 Rev 3 06 2020 ...
Page 66: ...Catalog No 29290 59 Rev 3 06 2020 ...
Page 67: ......