1
2
3
Try to turn the inner handle. It should move easily at the same time as
the large pin on the mortise lock is pulled in. If not, the lock may be
mounted at an angle to the door and must be adjusted. Make sure that
the square pin enters the center of the hole in the mounting bracket, If
the exterior part is mounted too tight to the bracket, the mortise lock
might be pinched. If so, try to release the screws a bit.
Insert the emergency key into the exterior handle and turn the key 90
degrees. The exterior handle should now be active, repeat step 1 and 2
with the outdoor handle. Turn the key back to the starting position and
remove it. Keep the emergency key in your pocket.
When everything is mounted, checked and fastened, test the lock
(KEEP THE DOOR OPEN) by entering the factory code on the exterior
part and the lock is now unlocked. The display flashes green and the
lock beeps before the door can be opened.
The factory set admin
code is 123 #
, and you always end the sequence with # (even after you
have changed the code to your own)
Before closing the door, read and
follow the instructions below!
IMPORTANT
ALWAYS TRY THE LOCK
BEFORE CLOSING THE DOOR.
For user administration, please
have a look at page 47.
CHECKLIST
For your own security, we are quite strict on this type of identification.
To ensure a proper identification, and to avoid your access being
denied, it is important that the finger rests calmly on the scanner.
Some people have shallow fingerprints and might have difficulty
being identified. In worst case they may not be identified at all.
The technology is constantly evolving, but your safety is always our
highest priority!
IMPORTANT INFORMATION REGARDING THE USE
OF FINGERPRINT
(Only WATTLE® DOOR PRO)
