4
5
6
On locks with Euro cylinder, fasten the
mounting bracket by using 3 of the
supplied machine screws from the back.
The top 2 screws should be the same
length as the door thickness. The lower
one should be 2 threaded pieces longer
than the thickness of the door.
Attach the rubber gasket on to the
mounting bracket and connect the cord
from the exterior part to the interior part
of the lock. The connector will only fit in
one orientation.
Carefully push the remaining cord into
the hole, towards the mortise lock, while
connecting the interior unit on to the
spindle. Push it all the way on, making
sure the gasket is not pinched.
Attach the inner unit to the bracket
by using the 3 shorter machine screws.
The longer one goes below the spindle.
The remaining two shorter ones goes
in the upper corners inside the battery
compartment.
Insert the supplied batteries (3x AA 1,5V).
Make sure to insert them in the right
direction The «-» pole should be facing
upwards in the middle, and downwards
on the 2 sides. Finally you should attach
the battery cover.
Attach the handles. They are attached
with two screws to the back of the
handle by using the included tool. The
batteries are expected to last for 6-12
months with normal use. When the lock
warns with several quick beeps when
opening the door, the batteries should
be replaced.
44
