2 0
■
Wa t l o w M
I N I
C
H E F
2 0 0 0
A p p l i c a t i o n 2
hold and count up time.
If the Hold time parameter
[Htine]
has been set to 0, the unit will count up time
indefinitely. The hold sequence will end when you cancel the current menu or acti-
vate another menu.
If Hold time
[Htine]
is greater than 0, the unit will run the hold sequence until the
hold time expires. It will then switch to the sequence described in 6.
6.
When the cook-&-hold cycle is finished, one of the following will happen, depending
on the way the controller was programmed at
[Etype]
/
[sound]
:
With Sound set to 0: The controller automatically switches to idle, in which the con-
troller does not maintain the temperatures at set point and does not run time.
[`idle]
or current time will appear on the display. The Start/Stop key indicator
light will be off.
With Sound set to 1, 2, or 3:
[``end]
will appear on the display and an audible tone
will be emitted. The Start/Stop key indicator light will flash rapidly. You can
acknowledge and silence the tone by pressing the Start/Stop key or it will automati-
cally time out within 2 seconds for setting 1 or 20 seconds for settings 2 or 3 and
then go into idle. The Start/Stop key indicator light will be off.
With sound set to 4 or 5:
[``end]
will appear on the display and the Start/Stop key
indicator light will flash rapidly. You must acknowledge the audible tone by pressing
the Start/Stop key. Once acknowledged the audible tone is silenced and the con-
troller goes into idle. The Start/Stop key indicator light will be off.
7.
Once the controller goes into idle, the Start/Stop key indicator light and heat out-
puts will switch off. The controller will not regulate to any temperature.
8.
To repeat cooking, repeat steps 1 through 5 or 6.
Pause a Menu
While cooking, you can pause cooking time by pressing the Start/Stop key once. The
Start/Stop key indicator light will flash rapidly.
[PAUSE]
will appear on the display.
Countdown time will resume when you press the active menu key again.
Cancel a Menu
Canceling a menu stops controller completely. The controller does not maintain set point
temperatures or run time. You cancel a menu to run another menu, stop menu operation
for any reason, or are preparing to shut off the oven.
•
Press the Start/Stop key for 2 seconds (in hold, momentarily press the Start/Stop
key). Heat outputs will switch off. Heat output indicator lights will switch off.
[`idle]
or time of day will be on the display. The fan will remain on for the time
set in Configuration Mode
[EtyPE]
/
[deLAY]
.
Restart a Menu
1.
If the controller is preheating or running a menu, cancel the menu by pressing and
holding the Start/Stop key for 2 seconds. If the controller is in
[`idle]
, go to 2.
2.
Press the Start/Stop key.
Based on its programming, the unit will run the menu in one of the ways described
earlier.