Revision 1.1
Page 29
REPLACEMENT COMPONENTS
Component
Part No.
Frequency of Replacement
UV Light, TUV-8W
CT-2001
Every 12 months, or as required
INN# 10-7020
UV Quartz Sleeve
CT-2002
Clean every 12 months, replace as needed
INN# 10-1400
10” Twist Carbon Block Filter,
1-Micron, Reverse-Threaded
PU-4029
Every 6-months, or 2,000 gallons, whichever
comes first. ** INN# 10-2801
10” Twist GAC filter, with
Polyphosphate Additive to
Reduce Scaling, Reverse-
Threaded
PU-4076
Every 6-months, or as required
** Local water conditions will determine
proper filter type and maintenance schedule.
INN# 10-7002
Replacement parts can be obtained from
Waterlogic
or an
Authorized Waterlogic Dealer
.
See Parts Layouts, Drawings, and Lists for additional repair parts.
Hot Tank HT-3021 Service
Hot Tank (with controls) must be replaced at least every 5 years.
Descaling hot tank may be required on a regular basis depending
upon filtration and local water conditions. See Service Section.
Hot Tank Assembly Part Number is HT-3021 (INN# 10-7082)
Sparkling Chamber Level Sensor Probe Assembly CT-2023
WL500
Sparkling chamber has a level sensor probe that needs to be
maintained and descaled at every filter change. Replace if needed.
Level Sensor Probe Part Number is CT-2023-A (INN# 10-7250)
NOTE:
WL500
comes with filtration pre-installed in the unit. Filters must
be rinsed before use. Never rinse through the WL500.
Filters may need to be modified or supplemented to best match
local water conditions.
WL500
Filters
are reverse thread and
a filter must be engaged in the 1
st
filter head to open the automatic
shut-off-valve and allow water to pass to the inlet solenoid.
See Installation Procedures and Filter By-Pass Instructions.
NOTE
:
At the
end of this product’s life
, ensure that it is disposed of
in an environmentally friendly manner which is fully compliant
with all Federal/State/Local Requirements and Guidelines.
CO
2
Pressure Regulator Part Number AK-0003-L00
Waterlogic
CO
2
Pressure Regulator with tamper proof adjuster, preset to
35-45 psi, single output pressure gauge, inline shut-off valve, ¼ quick
connect fitting, safety relief, and CO
2
CGA-320 thread adapter.