Revision 1.1
Page 10
OPERATING INSTRUCTIONS
The above picture shows front LCD display and control panel for the
Waterlogic WL500
.
Button
Operational Use
Programming Mode
1
Select Cold Water
Scroll the Menu Down
2
Select Sparkling Water
Scroll the Menu Up
3
Select Hot Water
Enter (select) an Option
on the Menu
4
Select Extra Hot water
Escape to Main Menu/Exit
Programming Mode
Main Dispense Button
(larger -not shown above)
Dispense Selection
N/A
For Cold Water:
Press Cold (Button 1) followed by the Main Dispense Button.
For Sparkling Water: Press Sparkling (Button 2) followed by the Main Dispense Button.
For Hot Water:
Press Hot (Button 3) followed by the Main Dispensing Button.
For Extra Hot Water: Press Extra Hot (Button 4), wait approximately 30 seconds. Then press
Hot (Button 3) and the Main Dispensing Button. This procedure will raise
the hot water temperature approximately 2
o
F. Repeating the process
over again will raise the temperature about 2
o
F more until the desired
temperature is reached up to a maximum limit of 203
o
F.
NOTE:
Default selection mode is Cold Water. Selection will return to default after 3 seconds of
inactivity. The default selection can be programmed to Cold or Sparkling. See Programming.
