Revision 1.1
Page 14
Once the level sensor detects the tank is full of water, the PCB will shut down sparkling water
generation (
Mizzling Process
). The
WL500
will return to the COLD default selection after 3
seconds. Cold and Hot water can be dispensed while sparkling water is being generated. The
sparkling water generation will stop as soon as sparkling water is dispensed or the chamber fills.
The
WL500
will make 1 liter (34 ounces) of sparkling water in approximately 1 minute, 20
seconds. Typically, users will only dispense up to ½ liter (17 ounces) of sparkling water at a
time, and the
WL500
takes about 40 seconds to regenerate sparkling water tank accordingly.
Waterlogic WL500
produces Premium Sparkling
Water which is made in a batch and contains a fine,
dense carbonation as compared to some “soda
water” products. Optimal sparkling water is
generated with cold water under 46
o
F.
WL500
Sparkling Level Sensor Probe requires
inspection and service. See Service Section.
WL500
Sleep Mode
The
WL500
has programmable sleep mode. When
sleep mode is ON the
WL500
will shut down the
heater circuit to conserve energy after the machine
is idle for 3 hours. The heater circuit will awake
once any button is depressed and it will reheat the
hot tank to set point temperature. “SLEEP MODE”
will be displayed. Always check Sleep Mode setting
if unit does not produce hot water as expected.
WL500
UV Protection
The
Waterlogic WL500
contains a germicidal
ultraviolet (UV) lamp that sterilizes water in the
cold tank and requires annual replacement.
The
WL500
has a UV CDS Sensor located in the Cap
of the UV Tank. UV Fault Mode Protection will
alert the user with a 20 second audible alarm and
display UV FAULT on screen when UV light is not
detected. UV Fault Mode Protection will shut off
cold/sparkling water to avoid potentially
dispensing unsafe water.
