Waterfall Audio RS700, Instructions Manual

Page: 21 / 34

- 18 -
3. CINEMA SET-UP : AMPLIFICATION FOR LCR300 OR LCR500 FRONT SPEAKERS
Configure the RS700 to power the speakers in "SPEAKER" mode, and ensure the right choice of speaker
model (see page 13).
In the speaker setup menu of the audio-video processor it is imperative to configure the speakers to small
mode (with the following crossovers : LCR500: 80Hz, LCR300: 100Hz).
U-GUARD™, T-GUARD™ technologies are active on amplified outputs (21). The illustration below shows
the wiring for only the front LCR channels.
Reminder: lThe W1.0 program is designed for Cinema applications where the speakers are filtered in high
pass (usually at 80Hz) by the audio-video processor. X-GUARD™ processing is not operational. Never set
speakers to WIDE/LARGE. Due to the high power, listening at very high volume levels in wideband/large
mode may risk mechanical damage to the bass speakers.
Reminder : Connections are to be made with all electronics turned off.
• Connect the PRE OUT FL & FR outputs from the audio video processor to one RS700 and
PRE OUT Center output to either one of the channels on a second RS700 to the ANALOG
INPUT (16) or (17) RCA or XLR inputs.
• Connect amplifier (21) outputs to the relevant speakers