Waterfall Audio RS700, Instructions Manual

Page: 29 / 34

- 26 -
RS700 IN « SUB » MODE WITH 2 x SUB600S
2 x SUB600S SETUP LOW-PASS 12dB Butterworth
• Switch (6) must be set to "AN” analog input
• Set switch (5) to XLR or RCA depending on the type of connector used
•
Switch (8) Filtering: must be set to Position 1
• Switch (7) PHASE) must be in the 180° position.
• The multifunction controller (3) (FREQ) manages the cut-off frequency of the low-pass filter (variable from 35 to 150 Hz).
• Switch (9) PROCESSING must be set to
Position 2 = X-GUARD™ for SUB600
Position 1 = X-GUARD™ for SUB600S
Position E = activates the X-GUARD™ and X-TEND™. This can only be used with SUB600S.
• When the connections and settings have been made, turn on the device with the main power switch (11) and switch MUTE
(4) to position 1. The volume control (1) must be positioned at the lowest position (fully counter clockwise) on start-up. Then
adjust the volume accordingly.
Points to note :
• The volume control (1) adjusts the volume on the L&R channels simultaneously
• XLR (18) outputs should not be used in this application
• S/PDIF digital links (19) and (20) should not be used in this application
• When switch (9) is in the “E” position, the X-GUARD™ and X-TEND™ functions optimize the extension in the sub bass
(20-35Hz band). This extension of the response at very low frequencies results in a lower SPL.
RS700 IN « SUB » MODE with 2 x SUB600S
2 x SUB600S SETUP LOW-PASS 24dB Linkwitz Riley
• Switch (6) must be set to "AN” analog input
• Set switch (5) to XLR or RCA depending on the type of connector used
• Switch (8) Filtering: must be set to Position 2
• Switch (7) PHASE) must be in the 0° position.
• The multifunction controller (3) (FREQ) manages the cut-off frequency of the low-pass filter (variable from 35 to 150 Hz).
• Switch (9) PROCESSING must be set to
Position 2 = X-GUARD™ for SUB600
Position 1 = X-GUARD™ for SUB600S
Position E = activates the X-GUARD™ and X-TEND™. This can only be used with SUB600S.
• When the connections and settings have been made, turn on the device with the main power switch (11) and switch MUTE
(4) to position 1. The volume control (1) must be positioned at the lowest position (fully counter clockwise) on start-up. Then
adjust the volume accordingly.
Points to note :
• XLR (18) outputs should only be used with an amp without DSP (so as not to induce any latency)
• S/PDIF digital links (19) and (20) should not be used in this application
• The volume control (1) adjusts the volume on the L&R channels simultaneously
• When switch (9) is in the “E” position, the X-GUARD™ and X-TEND™ functions optimize the extension in the sub bass
(20-35Hz band). This extension of the response at very low frequencies results in a lower SPL.