Waterfall Audio RS700, Instructions Manual

Page: 18 / 34

Control panel settings in CINEMA-SUB configuration
• Switch (6) must be set to "AN” analog input
• Set switch (5) to XLR or RCA depending on the type of connector used
• Switch (8) Filtering: Must be set to the FULL position
• Switch (9) Processing must be set to:
Position 2 = X-GUARD™ for SUB600
Position 1 = X-GUARD™ for SUB600S
Position E = activates the X-GUARD™ & X-TEND.™ Only for use with SUB600S
• Switch (7) Phase: Operates on the amplifier and the S/PDIF outputs.
• When the connections and settings have been made, turn on the device with the main power switch (11)
and switch MUTE (4) to position 1. The volume control (1) must be positioned at the lowest position (fully
counter clockwise) on start-up. Then adjust the volume accordingly
Points to note :
• The volume control (1) adjusts the volume on the L&R channels simultaneously.
• The multifunction controller (3) is inactive. The amplifier operates in LFE mode; the cut-off frequency is
handled directly by the AV processor.
• Depending on the "Bass Management" implemented by the Audio-Video processor it may be necessary
to use the phase reversal Switch (7).
• XLR (18) outputs should not be used in this application
• S/PDIF digital links (19) and (20) should not be used in this application.
• When switch (9) is in the “E” position, the X-GUARD™ and X-TEND™ functions optimize the extension in the
sub bass (20-35Hz band). This extension of the response at very low frequencies results in a lower SPL.
- 15 -