23
Adding a Sensor or Station Pup to an established network
Be sure the Retriever is in Setup mode (flashing amber). If it
isn't, press the button for 2 seconds. It may take up to 5 minutes
for the Retriever to transition to Setup mode.
Install batteries in the new Pup. The Pup will flash amber
while it tries to join. When successful, it will flash green 3
times. If it doesn't join, hold the red button on the Pup for 8-
10 seconds. This will re-start the meshing sequence. The
Pup may or may not flash amber but will flash green 3 times
when it has meshed.
Once meshed, the Pup will periodically flash green and
amber to indicate communication to the Retriever.
