Preparing to use the continuous feeding
25
5
© WASP S.r.l.
5.2. User interface
5.2.1. Main board
Legend:
1. ON/OFF Global: Use the green button to turn on the machine. Remember that as the system is turned on the
components will start moving. The red button serves as shutdown and also as emergency button.
2. ON/OFF Mixer: The mixer is automatically turned on with the global green button. You can use this button to
manually switch on and off the movement of the mixing unit.
3. ON/OFF Extruder: The extruder is automatically turned on with the global green button in case the machine is
not connected by cable to the 3D printer. You can use this button to manually switch on and off the movement
of the mixing unit.
4. FREQUENCY MIXER: Adjust the frequency of movement of the mixing unit. Reasonable values between 1.000
and 15.000
5. FREQUENCY EXTRUDER: Adjust the frequency of movement of the mixing unit. Reasonable values between
1.000 and 15.000
6. DUTY MIXER: Do not modify this value if you are not instructed to do so. By deafult is 50%. Reasonable values
between 20 and 50.
7. DUTY EXTRUDER: Do not modify this value if you are not instructed to do so. By deafult is 50%. Reasonable
values between 20 and 50.
Fig. 5.2.1 - Main board
SET
ON
FREQ/P
DUTY/N
+
-
+
-
SET
ON
FREQ/P
MIX
FREQUENCY MIXER
ON/OFF GLOBAL
FREQUENCY EXTRUDER
ON/OFF MIXER
ON/OFF EXTRUDER
DUTY/N
+
-
+
-
EXTR
DUTY MIXER
DUTY EXTRUDER
