10
1
© WASP S.r.l.
1.5. General safety warnings
CAUTION:
Any intervention must be performed on the machine, requires particular caution on the part of the
operator.
NOTE:
Any intervention on the machine must be carried out in strict compliance with the operational skills
(see paragraph 1.6.1 “Identification of Operational Personnel”). WASP S.r.l. declines any responsibility
in case of non-compliance with these skills.
The purpose of this chapter is to indicate which are the specific points and measures to avoid incurring any kind
of accidents, which may be defined as residual risks, which are the minimum essential safety provisions to be
maintained, which characteristics must have the personnel assigned to the normal assembly operations and
which must be the characteristics of the maintenance personnel.
We are not responsible for unspecified operations, as they are considered strictly pertinent to technical
assistance personnel or for operations performed differently from what we described in the documentation
presented.
Possible operations on the machine are:
• Mechanics
• Electrical
MECHANICAL NATURE INTERVENTIONS
Any intervention of a mechanical nature must be carried out in strict compliance with the directives required by
current safety regulations. It is absolutely forbidden to perform any type of mechanical maintenance intervention
on the machine during the operating cycle or in any case with parts of the machine moving.
Every mechanical adjustment operation must be carried out with the machine stopped and only and exclusively
by the mechanical maintenance technician, qualified to operate in conditions of protection disconnected (see
paragraph 1.6.1 “Identification of the operating personnel”).
Maintenance work must only be performed with the machine disconnected from the mains and taking all the
safety measures required by current regulations.
ATTENTION:
The components that grant the safety of the operator during the use of the machine must not be
disassembled or compromised for any reason. (Fig. 1.5 a and Fig 1.5 b)
Fig. 1.5 a - Make sure this screw is well tightened
Fig. 1.5 b - Do not remove the material intake protection
