warema_890558_alhb_en_v5•2022-02-01
We reserve the right to carry out improvements
20
Wisotronic 1-channel
Installation instructions
4.4 Installing the control
panel
The Wisotronic 1-channel is designed for installation in a flush-mounting box
(
2
); a surface-mounted housing (
) and a pattress box (
3
) are also avail-
able. The device is to be mounted in a dry and readily accessible location.
42
49
57
20
7
2
3
Fig. 6
Mounting options
WARNING
The device is intended for operation in interiors only.
Choose an installation height that permits convenient reading of the display
(recommended: bottom edge of the device approx. 1.45 m above the top
surface of the flooring).
A temperature sensor is integrated in the control panel itself. Therefore, to
prevent erroneous readings, do not install the control panel where a heat
source may influence the measurements (sunlight, radiator, outside wall).
The control panel is equipped with an EWFS radio receiver. The range of
radio controls is restricted by legal regulations for radio systems and through
structural factors. Adequate radio reception must be ensured when planning
the project. This applies especially if transmitter and receiver are in different
locations and the radio signal must pass through walls and ceilings. The
control unit should not be installed in the immediate vicinity of metal surfaces
(steel beam, fire door).
Therefore, check that the receiver is functioning properly before the final in-
stallation.
Strong local transmitter system (e.g. baby monitors or adjacent senders) with
transmission frequencies identical to that of the control system can interfere
with the reception.
Installation
