890557_d•en•01.07.2014
We reserve the right to carry out improvements
68
Wisotronic 1-channel
Operating instructions
7.2.6.2 SU1: switch time hh:mm
If the sun shading product or another product are to move at the same time
every Monday, you can set this switch time here. The setting range is 00:00
h to 23:59 h. If you do not want to move/switch the product on Monday, you
can also deactivate the switching time [
---
].
Turn the touch wheel to set the hours of the “ST1: switch time hh:mm”. Press-
ing on the wheel causes the display to jump to minutes. Set the minutes in
the same manner.
The [
---
] function button leaves the switch time unchanged; the [
Stand.
]
function button sets the product-specific factory setting.
7.2.6.3 SU1: position
The "ST1: Position" value specifies the position to which the sun shading
product is to move at switch time 1. The setting range is 0-100%; a value of
0% corresponds to the upper limit position and a value of 100% to the lower
limit position.
Turn the touch wheel to set the value “ST1: Position”.
The function button [
---
] leaves the position unchanged; the function
button [
Stand.
] sets the value for the “ST1: Position” to factory setting.
7.2.6.4 SU1: Slat angle
This setting is only useful when you have chosen a slat product (external or
internal venetian blinds). If you have connected a slat product (such as an
external venetian blind), you can specify how the slats are to be set after
movement to the "ST1" position is completed. This is especially useful if you
prefer a specific setting. In addition, you no longer need to tilt the slats manu-
ally after a time-controlled movement. The timer switch tilts the slats for you
if programmed accordingly. The factory setting for the slat position for timed
operation is -80° (
see Chapter 7.2.1.5 on page 38
).
Turn the touch wheel to set the value "ST1: Slat angle".
The function button [
---
] leaves the slat angle unchanged; the function but-
ton [
Stand.
] sets the value “ST1: Slat angle” to the factory setting.
7.2.6.5 SU1: Duto control
All comfort functions except for the dawn/dusk control and the timer switch
can be disabled and enabled at switch time 1. For this purpose, select
[
Disable
] or [
Enable
] under "ST1: Auto control".
If you select [unchanged] here, then the release settings ([
Disable
],
[
Enable
] or [
Unchanged
]) apply, that have previously been set by the last
switch time of the dawn/dusk control or the timer switch.
To set the desired automatic control, turn the touch wheel (the operating
modes change when the wheel is turned and are displayed on the left in the
menu line).
The function button [
---
] leaves the automatic control unchanged; function
button [
Stand.
] sets the factory setting.
Uime switch
