890557_d•en•01.07.2014
We reserve the right to carry out improvements
15
After you have set a desired value, you must press the touch wheel. This
causes this value to be adopted and the setting changes to the original col-
our. Another turn of the touch wheel does not cause the value to change but
moves the selection bar up or down once more.
Apart from setting numeric values, a selection of presettings as well as the
following operating elements can also be shown at the right side:
In the first line you will see a bar graph at the right. The current value and the
units are shown above the bar; the extreme values that can be set are shown
at the left and right of the bar graph. By turning the touch wheel, the bar
moves to the right or left; the value changes accordingly.
You will see a box in each of the two lines below. This value is deactivated if
it is empty. By selecting the line and turning the touch wheel, a checkmark
can be set in the bottom row of the illustration; this value is then activated.
Tilting products (External Venetian Blinds and Louvre Blinds)
The movement behaviour of these tilting or slat products when controlled
manually (on site or centrally via control panel) is as follows:
A brief push of the button (shorter than approx. 0.6 seconds) triggers a tilting
impulse of the slats.
A longer push of the button (longer than approx. 0.6 seconds) triggers a
movement.
Introduction
