W&T Com-Server++, Manual

Page: 65 / 228

65
W&T
The basis configuration of the Com-Server
Subject to error and alteration
8�3�5 Menu: SETUP System
r
Flash Update
Before you activate the update mode, make sure that you have
quit any active network connections. Then confirm with „y“.
The update mode is indicated by lighting of the Status LED on
the Com-Server.
WuTility automatically enables update mode through TCP port
8002. Manual enabling is therefore only necessary if this port
is blocked, such as by a firewall.
1 You may quit the update mode only by either
completely performing the update or by means of a re-
set, i.e. turning off the power!.
8�3�6 Menu: SETUP System
r
Factory Defaults
Enter a y to restore the factory default settings.
1 Resetting the non-volatile memory causes loss of all
the settings which deviate from the default values, inclu-
ding the IP address.
8�3�7 Menu: SETUP System
r
Reset
Select this menu item to perform a software reset on the
Com-Server. First your Telnet connection is properly closed.
1 All data from any still open network connections are
lost.
8�3�8 Menü: SETUP System
r
Link Speed
The Com-Server is factory set for autonegotiation. Data trans-
mission speed and duplex procedure are automatically negot-
iated with the connected switch/hub and set correspondingly.