W&H LINA MB17, Instructions For Use Manual

Page: 20 / 76

20
Table 1: list of the MENU options (continued)
Table 1: list of the MENU options (continued) Table 1: list of the MENU options (continued)
Table 1: list of the MENU options (continued)
MENU MENU MENU MENU SUB SUB SUB SUB----MENU MENU MENU MENU WHAT IT DOES WHAT IT DOES WHAT IT DOES WHAT IT DOES
(continued (continued (continued (continued
from from from from
previous
previous previous
previous
page) page) page) page)
(*)
(*) (*)
(*)
Prints traceability labels to be stuck to the load pouches.
Labels show the lot number and other parameters as specified in the LOT LABELS menu
(see SETUP table). The number of labels will be requested: press UP/DOWN to
increment/decrement the number, then press OK to print.
After printing, the lot number is incremented by 1.
Prints labels of a previous sterilization lot. The lot number and the number of labels will be
requested: press UP/DOWN to increment/decrement the numbers, then press OK to print.
Displays the device brand name; e.g. W&H.
Displays the device model name; e.g. LINA MB22.
Displays the serial number of the sterilizer; e.g. 110009.
Displays the total number of cycles executed by the sterilizer.
Displays the status (number of cycles executed) of consumables. Permits the user to reset
the counter to zero after replacing a consumable. See Chapter 7 (Maintenance) for details.
Displays the number of cycles executed compared to the 4000 cycle service.
Displays the number of cycles executed compared to the 20000 cycle service.
Displays the current software version.
Displays the current system software version.
Displays the current version of the power firmware.
Shows the identifier of the hardware key (label printer/service), if connected.
Displays the software version of the PC/logger device, if connected.
(*) available/effective only if an endorsed device (printer, logger, PC, water supply, etc.) is connected and enabled in the SETUP menu.