WALTHER PILOT wa 51, Operating Instruction

Page: 12 / 19

22 23
Contents
Exploded Drawing 4
Dimension Sheet 6
Declaration of CE-Conformity 23
List of Replacement Parts 24
1 General 25
1.1 Identification of Model Versions 25
1.2 Normal Use 25
1.3 Improper Use 26
2 Technical Description 26
3 Safety instructions 26
3.1 Identification of safety instructions 26
3.2 General Safety Instructions 27
4 Assembly 27
4.1 Mounting of the Spray Gun 28
4.2 Connection of Input Lines 28
5 Operational Handling 28
5.1 Safety Warnings 28
5.2 Starting / Stopping Requirements 29
5.3 Spray Pattern Test 29
5.4 Spray Pattern Adjustments 29
5.5 Retooling of Spray Gun 30
6 Cleaning and Maintenance 31
7 Repairs 32
7.1 Changing the Needle Seal 32
7.2 Replacement of Nozzles, Needles, Springs and Seals 32
8 Troubleshooting and Corrective Action 33
9 Disposal of Cleaning and Servicing 33
Substances
10 Technical Data 34
Declaration of EC/EU-Conformity
We, the manufacturers of the equipment, hereby declare under our sole responsibility
that the product(s) described below conform to the essential safety requirements. This
declaration will be rendered invalid if any changes are made to the equipment without
prior consultation with us.
Manufacturer WALTHER Spritz- und Lackiersysteme GmbH
Kärntner Str. 18 - 30
D - 42327 Wuppertal
Tel.: +49(0)202 / 787 - 0
Fax: +49(0)202 / 787 - 2217
www.walther-pilot.de • e-mail: info@walther-pilot.de
Type Designation Automatic spray gun PILOT WA 51
round jet V 20 306 51
wide/flat jet V 20 306 01
Intended purpose Processing of sprayable media
Applied Standards and Directives
EU-Mechanical Engineering Directives 2006/42/EC
2014/34/EU (ATEX Directives)
DIN EN ISO 12100
DIN EN 1953 DIN EN 13463-1
DIN EN 1127-1 DIN EN 13463-5
Specification according 2014/34/EU
Category 2 Part marking II 2 G c T 5
Tech.File,Ref.:
2406
Authorized with the compilation of the technical file:
Nico Kowalski, WALTHER Spritz- und Lackiersysteme GmbH, Kärntner Str. 18 - 30
D- 42327 Wuppertal
Special remarks :
The named product is intended for installation in other equipment. Commissioning is
prohibited until such time as the end product has been proved to conform to the
provision of the Directives 2006/42/EC.
Wuppertal, the 27th of April 2017
Name: Torsten Bröker
Position: Manager, Design and Development
This Declaration does not give assurance of properties in the sense of product liability. The safety instructions
provided in the product documentation must be observed at all times.
p.p.