7.5 Synthetic Rope Replacement
CAUTION!
Avoid the risk of rope failure. Do not replace rope
with one that is not approved for use on this
winch. Rope properties may be unknown and
failure could result. Refer to the parts manual for
replacement rope type.
W094
Rope Inspection
It is a good idea to check the entire rope for wear and re spool it
neatly after every use. Check the winch rope for any cut strands,
fraying parts, abrasion, or heat damage from the winch. After
use, all winch lines will get a little fuzzy from abrasion. This is
normal, but
if an entire strand is cut the winch line needs to
be replaced or fixed
. For the winch line to work properly and
maintain its strength, all strands must be intact.
Both heat and UV exposure break down the fibers of the
synthetic rope weakening it and making it brittle over time.
Frequent use in mud, dirt and sandy conditions can also
damage a synthetic rope if it is not properly cleaned and cared
for.
Cleaning Synthetic Rope
When dirt and grit become lodged in between the strands of the
winch line they cause abrasion to the fibers when the winch line
is put under a load. Over time this can cause a breakdown in the
integrity and strength of the rope.
Wash winch rope if it gets dirty by unspooling the entire line
from the winch and lay it on a clean surface. Once the line is
laid out, rinse it well with water from a hose.
To really get the strands free of dirt and grit, fill a bucket with
water and mild soap. Push together on the rope to open the
strands up and rinse in the water. Run the entire length of the
winch line through the water until it is cleaned.
WP245 / WP275
3-Point Hitch Firewood Processor
Service and Maintenance
43
