6.3 Machine Set-Up
Follow the steps on the next pages to set-up the machine at
the work site:
WARNING!
Engine exhaust contains carbon monoxide, an
odorless, poisonous gas. Breathing it can cause
unconsciousness or death.
Never operate engine in a closed, or even partly
closed area. Exhaust gases can build up to
dangerous levels.
W072
1.
Use the tractor to position the machine and set it down at
the work site.
2.
Remove the snapper pins securing the bracing jacks and
turn them up to the bracing position.
3.
Replace the snapper pins to secure the jacks.
NOTE:
Angle the jacks upward so they will contact the
ground evenly when the chute is lowered.
4.
Remove the latch pin that holds the chute lock arm to the
log loader chute.
5.
Pull the lock arm away from the chute and swing it down.
Secure it to the side of the frame with the latch pin.
Steps 6–14 are shown on the next page.
Fig. 23 –
Machine Set Up
3
4
5
6
2
7
8
9
10
9
Operating Instructions
WP245 / WP275
3-Point Hitch Firewood Processor
26
