Fig. 20 –
Gear box
Fig. 21 –
Anchor chain
5.3 Optional Power Pack, Connecting
In the event your tractor does not have hydraulic connections
at the rear of the tractor, the Hydraulic Power Pack must be
installed.
Tractors equipped with the optional power pack follow this
procedure:
Connect the Hydraulic System
1.
Align the splines and slide the gear box on the tractor PTO
shaft.
NOTE:
Make sure the PTO shaft is clean and free of dirt.
2.
Attach the anchor chain to an adjacent frame member to
prevent the gear box from turning and to hold the assembly
on the shaft.
3.
Route and secure hoses along the hitch with clips or plastic
ties to prevent binding and pinching.
4.
Remove the top pin and install the top link. Use the
turnbuckle to align the top link. Insert the pins and install
the retainers. Return the turnbuckle to its original length and
lock.
5.
Slowly raise the machine through its working range to make
sure the hydraulic components and linkages don't bottom
out.
6.
Level the machine front and rear, and side to side using the
jackscrew on the right arm and the turnbuckle on the top
link.
7.
To unhook from the tractor, reverse the above procedure.
Always park the machine in a dry, level area.
WARNING!
Hydraulic oil under pressure can penetrate the
skin or eyes causing serious injury.
• Tighten all connections before applying
pressure.
• Search for leaks with a piece of cardboard
or wood, not your hand. Take care to protect
hands and body from high-pressure fl uids.
Wear a face shield or goggles for eye
protection.
• If an accident occurs, see a doctor familiar
with this type of injury immediately.
W040
Attaching / Unhooking
WP245 / WP275
3-Point Hitch Firewood Processor
24
