wallas 40ea, Manual

Page: 21 / 41

40ea manual
- 20 -
The heater has been stopped
Local control.
The heater has been adjusted with the equipment control switch.
Set temp:16C
The user-set temperature is 16°C
Read temp:25C
The measured temperature of the room is 25°C
Volt:12.0V
The voltage is 12.0 V
V3.4
Remote starter’s software version
Frequently Asked Questions
No signal LED:
• Check whether the power source is connected correctly
• Check the accumulator charge
• Check the GSM signal
• Check the aerial connection
The green LED flashes with short intervals:
• Check whether the SIM card is in place
• Check if the PIN code has been disabled
• Check whether the SIM card is valid
The LED colour is red:
• Wait for 2 – 3 seconds for the unit to automatically restart.
• If it stays on, try to restart the 4430 unit by disconnecting the power source for 10 seconds.
• Please contact the equipment dealer.
Resetting the factory settings (Reset)
It is possible to restore the factory settings.
Proceed as follows:
• Disconnect the power source.
• Press the button “RELAY1” and keep it down.