Wallace Perimeter Security SPEEDGATE, Installation And Maintenance Manual

Page: 137 / 142

SPEEDGATE Installation and Maintenance Manual Revision 1 - MAY 2023
137
END USER BRIEFING INSTRUCTIONS
End User Briefing Instructions
The following instructions regarding intended operation of the gate shall be provided to the End User. This
is to be done by the installer as a required part of the installation procedures.
To reduce the risk of severe injury or
death:
READ AND FOLLOW ALL OF THESE
INSTRUCTIONS.
1. Ensure the installer of the SpeedGate has provided the End User with a complete review, demonstration
thereof, and supporting documentation of the following:
a. A complete copy of the Installation Manual, which will include mechanical and electrical drawings
and instructions for the proper operation and service of the gate system.
b. The normal Sequence of Operation as to how the Gate will behave in both the opening and closing
cycles:
i. When a controlled open command is given the gate panels begin to move from the closed
position.
ii. The gate panels will accelerate to the maximum operating speed until the gate panels reach
the pre-open position.
iii. At the pre-open position (factory set), the gates will decelerate and come to a controlled stop
at the fully open position.
iv. After receiving a controlled close command or elapse of the timer-to-close, the gate panels
will move from the open position to the close position.
v. The gate panels will accelerate to the maximum operating speed until they have passed the
pre-open position.
vi. At the pre-closed position, the gate panels will decelerate until they come to a fully closed
position.
c. The Obstruction Detection Devices and how the Gate will behave should any of these devices
encounter an obstruction. This must include the proper steps to take following both a “Soft
Shutdown” and a “Hard Shutdown”.
d. The electrical (on/off) disconnect within the electrical controls enclosure.
e. The manual disconnect / mechanical drive; how to properly use it and return the system back to
normal operation following use of the manual disconnect.
2. Never let children operate or play with gate controls, or play in the vicinity of the Gate. If a remote
control is provided with this system, always keep it away from children.