Getting Started
Power Connection
IMPORTANT: The set top box is designed to
operate on 220-240V AC, 50 Hz. Plug the power
cable to the mains socket outlet.
• After unpacking, allow the set top box to reach the
ambient room temperature before you connect the
device to the mains .
fi
g.
1
Antenna & Satellite Connection
• Use ANTENNA IN to connect to an antenna to your
receiver (
fi
g.
1
). You can also use ANTENNA OUT
to connect antenna to your TV through the set top
box with an appropriate antenna cable.
• Connect the satellite LNB cable to the LNB socket
of your receiver (
fi
g.
2
).
Power On-Off
Connect all cables before plugging the box into the
mains. After plugging in the mains cord of the set
top box to the mains supply, a light will be seen on
the front panel (Standby mode). When the set top
box is
fi
rst powered up, please wait until the box
is initialized before activating the receiver since
booting of software will take some time. Plug the
mains. Please wait until the unit is initialized. This
may take almost a minute.
This product conforms with the latest European
Union Power Consumption Regulations and
features a low power standby mode. The product
enters into the low power standby mode a few
seconds later after pressing the standby button
to turn off the unit. Until the low power mode is
activated, a clock will be displayed at the display.
When the low power mode is activated, the display
will be shut down. When you press the standby
button during low power mode, it may take a
minute until the product is initialized. However if
you press standby button before low power mode
is activated unit will be initialized in a couple of
seconds (Active standby mode). Although it is not
recommended for enviromental reasons, you may
disable low power mode in your product at setup
–con
fi
guration menu.
Auto Power Down
The timeout value of auto power down feature has
been set as four hours by factory default. After the
timeout value is reached and the Tv is not operated
, the TV will go off. (if Auto Power Down option is
enabled). The Automatic power-down can be set
as On or Off from the con
fi
guration menu.
Important Note:
If there is any ongoing
programme recording or if any EPG programme
recordings and/or manual recordings is set to a
nearby time, the unit does not switch to low power
mode and remains in active standby mode until
recording tasks have been
fi
nished. At low power
mode, the unit initializes a couple of minutes before
the actual time of the incoming recording task.
Important Note:
The unit initializes time to time
to receive updates from EPG broadcast in order
to sycnronize EPG recording tasks properly. After
getting updates, the unit switches to low power
mode automatically. This takes a short while and
it is not a malfunction.
fi
g.
2
8
01_TS7100_[GB]_DVB645_PVR_2712UK_10078521_50216711.indd Ksm1:8
05.04.2012 17:02:05
