Assembly
1.
Place intake filter (3) with the long cone into the gun housing.
2. Screw in grip (2) into the gun housing and tight en.
3. Slot in protective guard (1).
W
arning:
keep clear
of ti
p
250 bar
max.3600 ps
i
3
2
1
34
1SP4QSBZr
GB
Cleaning the unit (shutting down)
Remedy in case of faults
Type of malfunction
" 6OJUEPFTOPUTUBSU
# 6OJUEPFTOPUESBXJONBUFSJBM
$ 6OJUESBXTJONBUFSJBMCVUUIF
pressure does not build up
Possible cause
/PWPMUBHFBQQMJFE
2. Pressure setting too low.
0/0''TXJUDIEFGFDUJWF
3FMJFGWBMWFJTTFUUP413":
p
spray).
2.
Filter projects over the fluid level and
sucks air.
3. Filter clogged.
4. Suction hose/suction tube is loose, i.e.
the unit is sucking in outside air.
1. Tip heavily worn.
2. Tip too large.
3. Pressure setting too low.
4. Filter clogged.
5. Coating material flows through the
return hose when the relief valve is in
UIF413":
p
spray) position.
6. Packings sticky or worn.
7. Valve balls worn.
8. Valve seats worn.
Measures for eliminating the malfunction
1. Check voltage supply.
2. Turn up pressure control knob.
3. Replace.
4FUSFMJFGWBMWFUP13*.&
k
circulation).
2. Refill the coating material.
3. Clean or replace the filter.
4. Clean connecting points. Tighten suction tube.
1. Replace
2. For selection of a smaller tip, see Tip table on Page 40.
3. Turn pressure control knob clockwise to increase.
4. Clean or replace the filter.
5. Remove and clean or replace relief valve.
6. Remove and clean or replace packings.
7. Remove and replace valve balls.
8. Remove and replace valve seats.
9.
Remedy in case of faults
8.3
Cleaning Airless spray gun
1. Rinse Airless spray gun with an appropriate cleaning agent.
2. Clean tip thoroughly with appropriate cleaning agent so that
no coating material residue remains.
3. Thoroughly clean the outside of the Airless spray gun.
Intake filter in Airless spray gun
%JTBTTFNCMZ 'JH
1. Pull protective guard (1) forward vigorously.
2. Screw grip (2) out of the gun housing. Remove intake filter (3).
3. Intake filter congested or defective – replace.
